JLTi MK2 Tube Hybrid Amplifier and Lenehan Audio ML1 Speakers in BIBRA LAKE, Western Australia for sale
Never used JLTi Tube Hybrid Amp MK-2 and 2 Lenehan Audio ML1 speakers. the best in acoustics made in Australia. The Amp alone sells for $2000, both speakers for $2000, sold seperately if wanted, no swaps. Speakers come with aluminum flight cases.
JLTi Mk2 TECHNICAL DETAILS:
Hybrid Circuit, Tube Front End
Front End powered by unique Split Rails, Low Tension (much safer)
VSE type Constant Current Shunt Regulation for Tube Front-End.
Cryogenically treated Triodes
Solid State Monolithic IC Output Stage, Quasi Bi-Polar
T-Network Technology - dramatically lower back-EMF distortions.
35 Watts RMS (continuous) into 8 Ohm, 50W short term peak.
Output Stage Modules mounted on wood fibre board block for damping.
Unusual Power Supply for Output Module, very fast Low Joule
Superb Unity Gain Tube Front-End with 1MHz Bandwidth, called SLCF.
Unity Gain Tube Preamp Output on the Back Panel, also useful for Subs
Four Inputs, total 33dB Gain (enough for VSE upgraded SACD Players).
The Sound: Warmish like Tubes (because harmonically it has a sense of sounding right) but not euphonic and not sterile, very refined, with dynamic and soundstage capabilities to compete with the best.
Even most conventional Tubed amplifiers will not match the sonics of this Hybrid design - personal reviews & testimonials to come.
Designed for average to high efficiency loudspeakers, not high current delivery but more like SE designs, yet a bit more power.
LENEHAN ML1 SPEAKERS TECHNICAL DETAILS:
Cabinet: Composite 18 to 36mm HDF laminated to 3mm sprung steel plate.
Differential Cancellation bracing utilising 25mm hardwood dowel and 18mm Birch Plywood.
Crossover construction: Full hardwire hand build, all joints are high pressure low contact area cold weld sealed with Teflon amalgamated wrap.
12awg aircored inductors, low tension handwound double stabilised.
Metalised Polypropelene 250volt. Utilising copper film and foil bypass capacitors.
Dale Vishay non inductive wire wound 6.5 watt to 13 watt and Mundorf 10watt metal oxide depending on location in the circuit.
Tweeter: 1 inch chambered textile dome.
Mid-bass driver: 5.5 inch Nomex Diaphram.
Wiring: Solid core copper from 2 to 4 strands depending on location in the circuit.
Input connection: Eichmann cablepods.
Frequency response: 45 - 25Khz +/- 1.5db (in room).
Sensitivity: 86dB @ 2.83V/m .
Impedance: 8 ohms nominal.
Recommended amplifier power: 20-300W .
Cabinet dimensions (HxWxD): 325 x 170 x 255mm (12.8 x 6.7 x 10.0").
Weight (per speaker): 12 kg (26.4lbs).